Turn your Honda Talon 1000X into a high-clearance powerhouse that ignores the laws of gravity. This 8-inch SuperATV Portal Gear Lift redefines its footprint by adding a massive 8 inches of total width and a 1.5-inch forward and rear offset. This strategic expansion allows you to run aggressive, oversized tires while maintaining a rock-solid center of gravity for high-speed cornering and vertical climbs. By relocating the gear reduction to the hub, you effectively shield your transmission and axles from the brutal stress typically caused by larger rubber, ensuring your Talon stays as fast as it looks.
Engineered for the elite rider at Cheetah’s Powersports, this kit utilizes precision-ground 9310 alloy billet steel gears and a beefy 1.5-inch 4340 hardened steel driveshaft to handle extreme torque without a whisper. Whether you opt for the rugged cast aluminum or the premium billet housing, your internals are protected by Thermo-Tork® gaskets and rubber O-rings that create an impenetrable barrier against mud, silt and water. With a universal hub that adapts to all major bolt patterns, this portal system is the ultimate cornerstone for a truly custom, go-anywhere build.
Features:
- Available with billet or cast aluminum housing
- Cool, quiet, precision ground gears made from 9310 alloy billet steel
- 1.5 in. forward and rear offset
- Increases width by 4 in. per side (8 in. total)
- 1.5 in. diameter 4340 hardened steel driveshaft
- Housings use Thermo-Tork® gaskets and rubber O-rings that don’t let anything through
- Universal hub fits all major bolt patterns 
- Gear reduction reduces stress on your drivetrain
8” Portal Gear Lift Includes:
- (4) Assembled portal hub boxes complete with 9310 gears, seals, output shaft, Thermo-Tork® gaskets and thrust
- bearings
- (4) Specialized steel alloy backing plates
- (4) Universal hubs and precision-ground stainless steel slotted rotors with lugs
- (2) Rear bearing carriers
- (4) Steel caliper mounting plates
- (2) Heavy-duty lower ball joints preinstalled
- (8) Caliper mounting plate spacers
- Extended brake lines
- All required hardware, including recessed castle nut socket
Wheel Requirements:
- 22" or larger wheel required
- Wheels cannot exceed 5" backspacing
- Wheels need to have a center hole of at least 3.25" (82.55mm) or require a 1” wheel spacer
- This product can impact machine operation. Customer and/or user is responsible for ensuring that this product is compatible with their machine as currently configured, properly installed, and understands any impact this product has or might have on the machine's operation.
- âš California Proposition 65 Warning âš WARNING: This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.
