Dominate the deepest mud holes and steepest climbs with the SuperATV 6 Inch Portal Gear Lift for your Polaris Ranger XP 900. Cheetah’s Powersports brings you the ultimate drivetrain upgrade featuring a dual idler gear configuration that maximizes strength while providing a two inch total wheel offset for added stability. These portals are built with precision ground 9310 alloy billet steel gears to ensure your ride remains cool and quiet even under extreme loads. By providing a massive gear reduction directly at the hub, this system significantly reduces stress on your axles and transmission so you can run larger tires without worry.
Engineering excellence meets trail ready durability with a 1.5 inch diameter 4340 hardened steel drive shaft and advanced gaskets that keep internal components bone dry. Whether you choose the sleek billet or rugged cast aluminum housings, you are getting a lift kit that is lighter than the competition and compatible with all major bolt patterns thanks to the universal hub. This portal kit transforms your Ranger into a high clearance beast that maintains factory steering geometry for a smooth and predictable ride. Upgrade your machine today and experience why SuperATV is the gold standard for serious powersports enthusiasts.
Features:
- Available with billet or cast aluminum housings
- Dual idler gear configuration maximizes strength
- Cool, quiet, precision-ground gears made from 9310 alloy billet steel
- 1.5 in. diameter 4340 hardened steel drive shaft
- Housings use advanced gaskets or O-rings that don’t let anything through
- Universal hub fits all major bolt patterns
- Gear reduction reduces stress on your drivetrain
- Dual idler gear configuration adds a 1” front and rear offset - 2” total extension
- Lighter than the competition
6” Portal Gear Lift Includes:
- (4) Assembled portal hub boxes complete with 9310 gears, seals, output shaft, gaskets or O-rings, and thrust
- bearings
- (4) Universal hubs and precision-ground stainless steel slotted rotors with lugs
- (4) Specialized steel alloy backing plates
- (4) Steel caliper mounting plates
- (2) Steel steering arms
- Extended brake lines
- All required hardware, including recessed castle nut socket
Wheel Requirements:
- 18” or larger wheel required
- Cannot exceed 5” backspacing
- Wheels need to have a center hole of at least 3.25" (82.55mm) or require a 1” wheel spacer
- Frame stiffener does NOT fit High Lifter Edition
- This product can impact machine operation. Customer and/or user is responsible for ensuring that this product is compatible with their machine as currently configured, properly installed, and understands any impact this product has or might have on the machine's operation.
- âš California Proposition 65 Warning âš WARNING: This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.
