Your Can-Am Maverick X3 was built for speed, but adding larger tires for technical trails or deep mud can often lead to snapped axles and sluggish performance. The SuperATV 6 Inch Portal Gear Lift from Cheetah’s Powersports solves this by putting the power exactly where it belongs at the wheels. By utilizing a dual idler gear setup, this system provides the mechanical leverage needed to turn massive rubber while significantly decreasing the workload on your transmission. This means you can keep your foot on the floor with the confidence that your drivetrain is actually under less stress than it was with a factory setup.
Performance enthusiasts choose these portals because they offer a wider, more stable stance and massive ground clearance without ruining the high speed handling of the X3. The combination of precision ground 9310 alloy gears and hardened steel drive shafts ensures that your machine remains quiet and vibration free during aggressive driving. With advanced Thermo-Tork gaskets keeping the internals pristine and a lightweight design that doesn't bog you down, this kit is the ultimate upgrade for riders who refuse to compromise between raw power and mechanical longevity. Elevate your Maverick and dominate terrains that were previously off limits.
Features:
- Available with billet or cast aluminum housings
- Dual idler gear configuration maximizes strength
- Cool, quiet, precision-ground gears made from 9310 alloy billet steel
- 1.5 in. diameter 4340 hardened steel drive shaft
- Housings use Thermo-Tork® gaskets or O-rings that don’t let anything through
- Universal hub fits all major bolt patterns
- Gear reduction reduces stress on your drivetrain
- Dual idler gear configuration adds a 1” front and rear offset - 2” total extension
- Lighter than the competition
6” Portal Gear Lift Includes:
- (4) Assembled portal hub boxes complete with 9310 gears, seals, output shaft, gaskets, and thrust bearings
- (4) Universal hubs and precision-ground stainless steel slotted rotors with lugs
- (4) Specialized steel alloy backing plates
- (4) Steel caliper mounting plates
- (2) Steel steering arms
- (2) Steering stops (dual idler configuration only)
- Extended brake lines
- All required hardware, including recessed castle nut socket
Wheel Requirements:
- 18” or larger wheel required
- 18” wheels cannot exceed 4-1/2” backspacing
- 20” and larger wheels cannot exceed 5” backspacing
- Wheels need to have a center hole of at least 3.25" (82.55mm) or require a 1” wheel spacer
- This product can impact machine operation. Customer and/or user is responsible for ensuring that this product is compatible with their machine as currently configured, properly installed, and understands any impact this product has or might have on the machine's operation.
- âš California Proposition 65 Warning âš WARNING: This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.
