Give your Can-Am Outlander the extra clearance and capability to conquer tougher terrain with the SuperATV 6 Inch Portal Gear Lift. Precision-ground 9310 alloy gears run cool and quiet, while the 1.5-inch hardened 4340 steel drive shafts provide the muscle to handle hard riding.
Adding 4 inches per side, this portal system gives your Outlander an 8-inch wider stance for added stability on demanding trails. Leak-resistant bearings and seals help protect the gears, while the complete kit includes hardware, backing plates, brake lines and instructions for a full installation.
Features:
- Available with billet or cast aluminum housing
- 9310 alloy billet steel precision ground gears are cool and quiet
- Increases width by 4 in. per side (8 in. total)
- 1.5 in. diameter 4340 hardened steel drive shaft
- No leak bearings and seals
- Universal hubs can be set up to work with the following bolt patterns: 4/156, 4/137, 4/115 and 4/110
- Comes complete with all hardware, backing plates, brakes lines and instructions
2012–2018 Outlander 6” Portal Gear Lift Includes:
- (4) Assembled portal hub complete with 9310 gears, seals, output shaft, advanced, and thrust bearings
- (4) Universal hubs and stainless steel slotted rotors with ith lugs
- (4) Specialized steel alloy backing plates
- (3) Steel caliper mounting plates
- (3) Caliper mounting plate shims
- (2) Steel steering arms
- (2) Extended rear trailing arms
- Extended brake lines
- All required hardware, including recessed castle nut socket
2019+ Outlander 6” Portal Gear Lift Includes:
- (4) Assembled portal hub complete with 9310 gears, seals, output shaft, advanced, and thrust bearings
- (4) Universal hubs and stainless steel slotted rotors with ith lugs
- (4) Specialized steel alloy backing plates
- (3) Steel caliper mounting plates
- (3) Caliper mounting plate shims
- (2) Steel steering arms
- (2) Extended Trailing arms (only if SATV trailing arms are not already installed)
- Extended brake lines
- All required hardware, including recessed castle nut socket
Wheel Requirements:
- 18” or larger wheel required
- 18” wheels cannot exceed 4-1/2” backspacing
- 20” wheels cannot exceed 5” backspacing
- Wheels need to have a center hole of at least 3.25" (82.55mm) or require a 1” wheel spacer
- This portal kit requires the use of SATV rear trailing arms
- This product can impact machine operation. Customer and/or user is responsible for ensuring that this product is compatible with their machine as currently configured, properly installed, and understands any impact this product has or might have on the machine's operation.
- ⚠ California Proposition 65 Warning ⚠ WARNING: This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.
